Drilling Topic Questions
Subscribe to the 'Drilling' topic to help and get support from people like you.
We found 11 unanswered questions associated with the 'Drilling' topic. Displaying results 1 - 10.
You are assigned to design 1000 bbl of drilling mud with density of 12 ppg using Bentonite, 200?
... sacks of Barite and fresh water. The specific gravity of Bentonite and Barite are 2.5 and 4.3 respectively. (a) Determine the amount of each ...
Posted 3+ months ago | 0 answers | 
| Open
Related topics: fresh, water, mud, design, gravity, density, drilling, sack
Please could you show me how to work out the question below, thanks in advance?
Using arithmetic and geometric progressions work out the following: An oil rig drills to a depth of 1000metres. Estimate the cost of drilling if the ...
Posted 3+ months ago | 0 answers | | Open
Related topics: work, oil, geometric, depth, below, cost, drilling, drill, question
Drilling screws into sliding glass door?
I have installed a new pet door next to my sliding glass door. The door's instructions asks me to drill screws into my door to fit its latch in. ...
Posted 3+ months ago | 0 answers | | Open
Related topics: pet, door, sliding, latch, drilling, drill, instructions
"Drilling parameters effect on drilling process (oil and gas)"?
Could you give me some information for this topic?
Posted 3+ months ago | 0 answers | | Open
Related topics: oil, information, gas, drilling
Drilling - Where must you set your downfeed tourge to start a triple tube hole?
Posted 3+ months ago | 0 answers | | Open
Drilling - How is possible execute a geotechnical hole with no dip and Azimouth deviation?
This question is related to grout curtain execution below dam foundation With around 100 m. Dept,25 degree dip from vertical and 120 degree azimouth
Posted 3+ months ago | 0 answers | | Open
Related topics: hole, curtain, degrees, below, foundation, drilling, question, degree
Drilling - After hanging the casing what should you do if you notice a increase in flow?
So Does this mean that the well is kicking and the well needs to be shut in before it reaches the surface and should you stop pumping at that point ?
Posted 3+ months ago | 0 answers | | Open
What are some alternative methods to acquire oil that does not involve drilling?
Posted 3+ months ago | 0 answers | | Open
Related topics: oil, alternative, drilling
Drilling - How is possible to keep the hole under planned dip and direction?
These drilling are for grout curtain execution under dam foundation for water tightening with 56 mm diameter ,100 meter depth and 25 degree dip from ...
Posted 3+ months ago | 0 answers | | Open
Related topics: water, hole, direction, depth, under, curtain, degrees, meter, foundation, drilling, degree
I'm a jr. drilling engineer who is working in Canada. Have a question regarding the torque value?
... when drilling in sliding mode. Theoretically, when drilling the hole in sliding mode, we can not get a torque value because the top drive is not ...
Posted 3+ months ago | 0 answers | | Open
Related topics: canada, hole, drive, sliding, working, mode, drilling, question, engineer